Effect of temperature effect

Effect of temperature effect

  • 11/01/2019 09:17:46

At room temperature, the post-forming of the laminate can only be bent to a large radius of curvature, which requires a small change in the size of the trimeric amine layer or the phenolic layer. As th…

Read more

Post-forming of laminate

Post-forming of laminate

  • 10/01/2019 08:56:38

For most decorative veneers, flat panels are perfectly acceptable. But in many cases, the design and manufacturer would like to make the laminate into a three-dimensional shape. For example, if the kit…

Read more

Laminate inspection

Laminate inspection

  • 09/01/2019 09:26:04

The specifications for decorative laminates and the corresponding test methods are issued by NEMA. They include thickness, wear, scratches, impact, dimensional changes, resistance to boiling water, sta…

Read more

Universal laminate

Universal laminate

  • 08/01/2019 08:56:04

Universal laminates are made in a range of different thicknesses. The laminates have been 1.6 mm thick for many years. With the improvement of production methods and decorative paper opacity, it has tu…

Read more
Decorative laminate

Decorative laminate

  • 07/01/2019 09:01:37

Any plastic laminate having a decorative layer on at least one side is referred to as a decorative laminate. Decorative laminates account for the vast majority of commercial plastic laminates produced …

Read more

Rolling and finishing

Rolling and finishing

  • 04/01/2019 09:02:15

The final step in the laminate manufacturing process is the rolling of the press load and the finishing of the resulting panel. The beginning was to move the stack of paper (ie "books") from …

Read more

Laminate press

Laminate press

  • 03/01/2019 09:01:07

The press load is heated with hot water that circulates through the heat exchange plates between the stacks. It takes time to get the heat to the center of the stack. The time-temperature system is des…

Read more

press

press

  • 02/01/2019 10:03:04

The hydraulic press used to make high-pressure plastic laminates is the most expensive equipment in the process. Therefore, all other processes are designed to operate at full capacity while minimizing…

Read more

Hot News

Exposure to external laminates

Exposure to external laminates

Because many laminates use a lot of core paper, many people have chosen to weigh rather than count the number of sheets for each laminate. Since the 10-20mm laminate is very rigid, all panels must be straight. Any significant warpage makes the panel unusa

Outdoor exposed laminate

Outdoor exposed laminate

The surface of ordinary melamine-formaldehyde resin used for veneers does not stand well when exposed to the atmosphere. Melamine begins to crack after a short exposure. The effect of light on such surfaces is to give the laminate a gray appearance. Initi

Fireproof or flame retardant laminate

Fireproof or flame retardant laminate

When plastic laminates are used in hospitals, airports, and other public buildings, fire protection regulations sometimes require laminates to be resistant or fire resistant.This usually means that they must pass the tests designed by the insurance compan

Special surface laminate

Special surface laminate

In order to achieve a certain aesthetic effect, there are many special surfaces that can be applied to the veneer. Wood chips, rattan and fabrics (such as burlap) have been used for this purpose. These materials are typically saturated with melamine-forma

Automated post forming machine

Automated post forming machine

In an automated post-forming machine, the plastic laminate is heated as it moves under a heat source, which is often a radiant heater. The surface is 156 C - 162 C. This temperature value can be changed by changing the heat source temperature, the dista

Tags