Electric drive and control unit

Electric drive and control unit
Whenever a production process is described, an always important part is always ignored or taken for granted. Early extrusion coating, a composite operation,
Installation of electrical drives and controls is approximately 7%-8% of the line price. At present, electric drive and other devices account for 20%-25% of the production line price.
The programming logic controller (PLC) plays an important role in the hypothetical responsiveness of the mechanical component operating logic. PLC has reduced the number of wires between electrical components and provides diagnostic and correction components and/or production line blocks. A great tool for faults in operation.
Current electric drives can be used with DC drives, variable frequency drives, DC and variable frequency combined drives, computer or digitally operated electric drives, all of which have a beneficial effect on the processing unit.
The control room containing the following electrical components in an air-conditioned room has proven to be cost-effective during the installation of a modern extrusion coating line and has also proven to be beneficial in troubleshooting faults in the production line:
(1) transmission gear and its auxiliary device;
(2) main conversion gear;
(3) Motor Control Center;
(4) programming logic controller;
(5) a separate transformer;
(6) Test instrument;
(7) Various driving devices for other auxiliary equipment.
The controlled transmission and control room facilitate installation and troubleshooting.

  • 06/11/2018
  • Recently
Click here to view Previous or Next

Related News

Casting PA film and production technology

Casting PA film and production technology

  • 21/12/2017 09:33:12

Casting PA film and production technology 1. Casting PA film and its raw materials used: PA film has the advantages of high strength, good toughness, good transparency, good heat resistance and cold…

Read more

Cast film mechanical winding device

Cast film mechanical winding device

  • 19/12/2017 09:21:48

Cast film mechanical winding device Corona treatment device: cast film after corona treatment, can improve the surface tension of the film to improve the printing of the film and together with other…

Read more

Downstream production line auxiliaries

Downstream production line auxiliaries

  • 18/12/2017 09:42:18

Downstream production line auxiliaries Thickness measurement device: In the high-speed continuous production process, cast film thickness measurement must be non-contact automatic tracking. Most o…

Read more

Casting film production line in the cooling device

Casting film production line in the cooling device

  • 15/12/2017 10:03:16

Casting film production line in the cooling device Casting production line in the cooling device mainly by the rack, cooling roller, peel roller, refrigeration system and air knife, auxiliary device…

Read more

Hot News

Outdoor exposed laminate

Outdoor exposed laminate

The surface of ordinary melamine-formaldehyde resin used for veneers does not stand well when exposed to the atmosphere. Melamine begins to crack after a short exposure. The effect of light on such surfaces is to give the laminate a gray appearance. Initi

Fireproof or flame retardant laminate

Fireproof or flame retardant laminate

When plastic laminates are used in hospitals, airports, and other public buildings, fire protection regulations sometimes require laminates to be resistant or fire resistant.This usually means that they must pass the tests designed by the insurance compan

Special surface laminate

Special surface laminate

In order to achieve a certain aesthetic effect, there are many special surfaces that can be applied to the veneer. Wood chips, rattan and fabrics (such as burlap) have been used for this purpose. These materials are typically saturated with melamine-forma

Automated post forming machine

Automated post forming machine

In an automated post-forming machine, the plastic laminate is heated as it moves under a heat source, which is often a radiant heater. The surface is 156 C - 162 C. This temperature value can be changed by changing the heat source temperature, the dista

Post-forming improvement

Post-forming improvement

Many other methods have been suggested as a way to make better post-formed laminates. One of them is to spray a few chemicals on the dry impregnated paper to reduce hydrogen bonding E39,423 in the paper immediately prior to impregnation of the phenolic re

Tags